1523.5-0000010 OM
52
ATTENTION: THE “DAMPENING” MODE IS ACTIVE ONLY WHEN HANDLE 11 IS IN
THE “UPLIFT” POSITION!
ATTENTION: DURING FIELD WORK (TILLAGE, CULTIVATION, ETC.) THE “DAMPEN-
ING” MODE SHALL BE TURNED OFF!
Your tractor can be equipped with the RLL control panel
ПУ
-03 manufactured by “Iz-
meritel” plant and shown in figure 2.17.2.
1 – handle of lift linkage control (position 16 – uplift; position 15 – off; position 14 – lower-
ing (in operation – automatic control); position 3 – mode of implement deepening in case it
raises (non-fixed)); 2 –retainer to lock the lift linkage control handle; 4 – annunciator of
linkage uplifting (red color); 5 – handle to adjust depth of soil tillage; 6 – troubleshooting
annunciator (red color); 7 – handle to adjust height limit of linkage uplifting; 8 – “dampen-
ing” button; 9 – “dampening” annunciator (green color); 10 – handle to adjust speed of
lowering; 11 – RLL position indicator (green color, upper scale point – RLL in max. raised
position, lower scale point – RLL fully lowered); 12 – handle to select control method; 13 –
annunciator of linkage lowering (green color).
Figure 2.17.2 – Rear lift linkage control panel
ПУ
-03
Note – RLL position indicator 11 (figure 2.17.2) is not used on “BELARUS-1523.5”
tractors.
The rules on using the RLL control panel
ПУ
-03 manufactured by “Izmeritel” plant are sim-
ilar to the rules on using the RLL control panel produced by “BOSCH” company, shown in
figure 2.17.1.
2.17.3 Remote buttons of RLL control system
Remote buttons of RLL control are used as a rule for coupling agricultural implements and
machines to the rear lift linkage.
Uplift and lowering of the rear lift linkage with remote buttons on rear wheel fenders can be
carried out at different control modes – handles 4, 6, 7, 8, 11 (figure 2.17.1) and similar
handles of the RLL control console
ПУ
-03 can be left in any position, as the system of con-
trol from inside the cab is blocked in this case.
To lift the RLL, press any of buttons 4 (figure 2.17.3) and hold it pressed. To lower the
RLL, press any of buttons 5 and hold it pressed.
For safety reasons control with remote buttons shall be performed with interruption of
work. Pressing uplift button 4 (lowering button 5) and holding it pressed lifts up (lowers) the
RLL for 5 sec., then it stops. For further uplifting (lowering) it is necessary to press the cor-
responding button once again and hold it pressed!
Then after attaching the implement, activation and operation with RLL shall be performed
in accordance with subsection 2.17.2.
