1523.6-0000010 OM
113
4.4.3 Drawbar hitch DH-
З
V (long towing yoke)
Figure 4.4.2 – Installation variant diagram of DH-
З
V (long towing yoke)
Table 4.4.2 – Basic parameters and coupling dimensions of DH-
З
V (long towing
yoke)
Standard size (configuration)
DH -3V (long towing yoke)
1 Mounting location
Rear lifting device
2 Design features
Rotational, height adjustable
3 Assignment
For coupling of trailed implements, in-
cluding tractor trailer type equipped with
drawbar clevises
4 DH yoke dimensions, mm:
а
) connecting pin diameter
b) yoke position
1)
for the implements driven
by rear PTO shaft
c) distance between the PTO butt end and
the connecting pin axis
40
Lower position, as shown in figure 4.4.2
400
5 Trailing device for coupling to DH:
а
) type
Rigid, with tractor drawbar clevis
b) vertical load in hitch point, kN, not more
than
20
c) turning angle of the implement trailing de-
vice in horizontal plane, degrees, not less
than
±60
d) protective device type
Safety chain (rope)
2)
e) connection point of the protective device
on the tractor
Lifting device openings
____________________________________________________________________
1)
Recommended.
2)
Implement accessories.
ATTENTION: IT IS FORBIDDEN TO PUT DH-3V YOKE TO A POSITION WHERE ITS
BODY OVERHANGS THE DH SUPPORTING BRACKET END (UP AND DOWN) FOR
MORE THAN 15
ММ
!
