1523.6-0000010 OM
115
4.4.5 Drawbar hitch DH-1
М
-01 (draw bar)
Figure 4.4.4 – Installation variant diagram of DH-1
М
-01 (draw bar)
Table 4.4.4 – Basic parameters and coupling dimensions of DH -1
М
-01(draw bar)
Standard size (configuration)
DH -1
М
-01 (draw bar)
1 Variant
First position
Second position
2 Mounting location
At the bottom of the rear axis body
and rear lifting device
3 Assignment
For connection and coupling of
trailed, semi-trailed implements with
traveling wheels, excluding tractor
trailers and semi-trailers
4 Design features
Draw bar with possibility to change its
horizontal position in relation to the
RPTO butt end
5 Distance between the PTO butt end and the
connecting pin axis, mm
400 500
6 Vertical load on DH in hitch point, kN, not more
than
15 12
7 Turning angle of the implement trailing device in
horizontal plane, degrees, not less than
±60
8 Connecting pin diameter, mm
30
9 Protective device type
Safety chain (rope)
1)
10 Connection point of the protective device on
the tractor
Lifting device openings
___________________________________________________________________________________________________________
1)
Implement
accessory.
ATTENTION: MOUNTING OF COVER PLATE ON THE DRAW BAR BOTTOM (WITH
OVERTURN) TO REDUCE HEIGHT OF YOKE POSITIONING IN RELATION TO THE
SUPPORTING SURFACE IS NOT ALLOWED!
