1523.6-0000010 OM
14
Table 1.2.1 finished
Parameter
(specification) designation
Parameter value for tractor
“BELARUS -1523.6“
20 Operating equipment:
а
) rear power take-off shaft:
In subsection 3.2.7 “PTO use”
b) front power take-off shaft:
In subsection 3.2.7 “PTO use”
c) rear lift linkage:
1) load-lifting capacity of rear lift linkage on
the suspension axle, kg, at least
6500
2) rear lift linkage lifting time from lower-
most to uppermost position with test load
on the suspension axle, s, at least
5
d) drawbar hitch:
In section 4 “Coupling of implements”
_____________________________________________________________________
________________________________________
1)
Engine parameters, not specified in table 1.2.1, shall comply with 260S4 – 0000100
OM document.
2)
For referential use.
3)
Without a creeper. Installation of a creeper against order provides additional four
speeds for forward travel and four speeds for the reverse.
4)
To be specified depending on configuration.
5)
With ballast mounted.
6)
Tractor operation with this track is possible only with removed front wheel fenders. It
is allowed only for countries, where tractor operation with removed front wheel fenders
is permitted according to statutory acts.
Note – In Table 1.2.1 the number of gears and tractor travel speed at engine shaft rated
speed are specified for tractors BELARUS-1523.6 with installed GB 16
х
8 (basic configura-
tion). The number of gears and travel speed for tractors BELARUS-1523.6 with installed
GB 24
х
12 (custom design) are specified in subsection 2.27 “Gears and ranges shifting of
GB 24
х
12”.
