BELARUS-
1523/1523В
/1523.3
/1523В.3
Tractor storage
279
TRACTOR STORAGE
Prior to putting the tractor for long-term
storage, perform the following opera-
tions:
•
Clean the tractor.
•
Place the tractor under a shed or in-
doors.
•
Gun-grease all the lubrication points:
— FDA;
— HPS;
— Clutch;
— RHL.
•
Drain coolant from the engine cooling
system.
•
Drain oil from the engine crankcase
and fuel pump body; clean the rotor of
the centrifugal oil filter.
•
Drain oil from the power transmission
housings, HLL and HPS oil tanks the
FDA hub reduction gear boxes and fi-
nal drive casings. Then, refill with
fresh clean oil with AKOP-1 additive.
•
Fill in the engine crankcase, fuel pump
body with preservation oil K-17, State
Standard (
ГОСТ
) 10877-76 or fresh de-
hydrated oil with 5% AKOP-1, State
Standard (ГОСТ)
15171-78 additive.
Prior to using the AKOP-1 additive,
mix thoroughly the engine oil and the
additive.
•
Start the engine and let it run for
15...30 s at low rotational speed.
•
Stop the engine and drain the preser-
vation oil from the engine crankcase
and the fuel pump body.
•
Discharge sediments and sludge from
the fuel coarse and fine filters.
•
Remove and charge storage batteries,
then, put them in store in dry well-
ventilated premises, with temperature
of 15..20
°
С.
Check the storage batter-
ies once a month and recharge them,
if required.
•
Lower the RHL linkage to its bottom
position.
•
Slacken tension of the alternator and
fan driving belts.
•
Cover the exhaust pipe and monocyc-
lon openings with a jacket.
•
Place the tractor onto stands to relieve
the front and rear tyres. Reduce the
pressure in the tyres down to 70% of
the normal operating value.
•
During the period of storage, turn the
engine crankshaft by several revolu-
tions at least once a month.
To remove the tractor from a long-term
storage, perform the following opera-
tions:
•
Remove the tractor from stands and
bring the pressure in the tyres to its
normal value.
•
Fill up fuel tanks.
•
Fill in the engine with coolant and oil.
Check the oil level in all the
tanks/bottles to be filled up.
•
Re-install fully charged storage batter-
ies back on the tractor.
•
Remove the jacket from the exhaust
pipe and the monocyclon.
•
Start the engine and carry out the
functional checks on all the tractor in-
struments, controls and systems.
•
Check the lighting and audible signal-
ling devices for proper functioning.
•
Run the tractor without loading to de-
termine whether it operates properly.
Summary of Contents for 1523
