2122.6-0000010 OM
140
1 – center pin; 2 – handle for lifting center pin; 3 – handle; 4 – yoke rear wall; 5 – detent.
Figure 4.4.7 – Coupling clevis KU2000/329NB33
To change the attaching points in the coupling clevis lifting device along the height, it is re-
quired to turn handle 3 (figure 4.4.7), after which the coupling clevis shall come down and get fixed in
the next lower fasteners of the lifting device. To mount the coupling clevis up along the height, it is
required to turn handle 3, after which pull handle 3 up. The coupling clevis shall get fixed in the next
upper openings of the lifting device.
To couple agricultural machines to the coupling clevis, it is required to uplift center pin 1 by turn-
ing handle 2. After that move the tractor closer to the agricultural machine. At the moment of contact
between the agricultural machine towing eye with the rear wall of yoke 4, detent 5 shall come into ac-
tion and center pin 1 shall come down providing coupling between the agricultural machine and the
tractor.
On agreement with MTW, the customer is allowed to purchase the coupling clevis manufac-
tured by another company rather than “Walterscheid” and mount it onto the tractor, if the parame-
ters and coupling dimensions of this coupling clevis comply with the parameters and coupling di-
mensions set forth in Table 4.4.6.
ATTENTION: WHEN COUPLING TRAILERS, TRAILED MACHINES, SEMI-TRAILERS
AND SEMI-TRAILED MACHINES TO THE COUPLING CLEVIS AS A PART OF DRAWBAR
HITCH, IT IS REQUIRED TO TAKE INTO ACCOUNT THAT PERMISSIBLE LOAD IN THE HITCH
POINT IN THE LONGITUDINAL DIRECTION SHALL CONSTITUTE NOT MORE THAN 70.1 kN
(INDICATED ON THE LIFTING DEVICE SIDE MEMBERS), REGARDLESS OF THE VALUE IN-
DICATED ON THE AUTOMATED DEVICE PLATE!
Table 4.4.7 – Basic parameters and coupling dimensions of coupling clevis KU5410/329-33
Standard size (configuration)
Coupling clevis KU5410/329-33
1 Mounting location
Rear lifting device
2 Design features
Towing yoke – rotating, located at the lifting
device, with the possibility of height adjust-
ment
3 Function
To couple towed agricultural trailed and semi-
trailed machines with running wheels includ-
ing the type of tractor trailers and semi-
trailers
4 DH yoke dimensions, mm:
а
) connecting pin diameter
31
b) yoke position
1)
for machines with rear PTO
drive
Lower, as shown in figure 4.4.6
c) distance between the rear PTO butt end and
the connecting pin axis
160
5 Towing device for coupling to DH:
а
) type
Rigid, with a towing eye
b) vertical load in the hitch point, kN, not more
than
20
c) turning angle of the machine towing device
in horizontal plane, degrees, at least
±65
d) protective device type
Chain or safety rope
e) connection point of the protective device on
the tractor
Lifting device openings
е
) relative calculated value of axial forces (D),
kN, not more than
70.1
1)
Recommended.
https://tractormanualz.com/
