Section E. Unitizing Belarus-510/512 — Operating manual
48
Mounting machines to the tractor
1. When mounting machines to the tractor,
first make sure that no one is present in
the zone of mounting the machine.
2. Using the handle of the power regulator (if
available), lower the suspension to the
lower position, drive the tractor back and
attach the machine to the lower rods.
Splint the fingers. Stop the engine.
3. Lengthen or shorten the upper rod (1) and
link the rod ball joint to the machine. Splint
the finger.
4. If necessary, adjust the upper rod to the
initial or desired length.
5. If necessary, adjust the transverse tilt
of the machine using the right adjust-
able brace (2). To increase the brace
length, turn the lever (3) clockwise and
vice versa.
6. Before you start working, make sure that:
• the tractor don't be in dangerous prox-
imity to the machine elements;
• the upper rod do not touch the PTO
guard at the lowermost position of the
machine;
• the PTO cardan drive be not too long,
with large joint angles, and that there be
no thrust forces;
• the PTO guard do not touch the ma-
chine cardan drive guard.
7. Slowly lift the machine and check avail-
ability of clearances of 100 mm min. be-
tween the wheel and the machine in the
raised position.
8. Check availability of the required side
oscillation of the lower rods and, as nec-
essary, adjust with the braces.