DCX XCONNECT CABINET: SYSTEM
PX106864 - EN REV A
Page 12 of 48
INSTALLATION GUIDE
3.4. Bolt Cabinets/Modules Back-to-Back
1.
Place Cabinets (or Modules) Back-to-Back by making sure that the rear ganging holes are aligned (it is assumed that at this point the
Cabinets or Modules have been placed in position and leveled).
Using the provided hardware kit (
DCX-GANG-KIT01
), place one 5/16 -18 bolts and tooth washer through one of the adjoined Cabinets (or
Modules placed at this position).
Repeat this process through the remaining (5) holes on the perimeter of the Cabinet (or Module).
2.
On the opposite Cabinet (or Module), attach one 5/16 tooth washer and nut to the protruding bolts.
Repeat this process for the (5) remaining bolts and tighten down the nuts, by drawing the two cabinets flush together.
Repeat this process for the (2) rows of Cabinets placed Back-to-Back that require the installation of the Modules
NOTE:
Refer to the next page to see how the Modules are ganged as Back-to-Back.
Ganging bolt
Tooth washer
(Opposite) tooth
washer secured
Nut (thigthen)
Top detailed view of the selected Cabinet:
The
Isometric view has been purposely rotated to
show the required hardware to be inserted, same
goes for the second detailed view below.
Side detailed view of the Cabinets
5x
5x
