DCX XCONNECT CABINET: SYSTEM
PX106864 - EN REV A
Page 9 of 48
INSTALLATION GUIDE
3.3. Bolt Cabinets/Module Side-to-Side
1.
Place Cabinets (
or the opposite Cabinet with Module)
Side-to-Side making sure that the side ganging holes/slots are aligned (it is assumed
that at this point the
Cabinets and Module have been placed in position and leveled).
Using the provided hardware kit (
DCX-GANG-KIT01
), place one 5/16 -18 bolts and tooth washer through one of
the adjoined Cabinets (or the Module placed).
Repeat this process through the remaining (5) holes on the perimeter of the Cabinet (or the Module).
2.
On the opposite side of the Cabinet attach one 5/16 tooth washer and nut to the protruding bolts.
Repeat this process for the (5) remaining bolts and tighten down the nuts, by drawing the two Cabinets (or the
Cabinet and
Module)
flush together.
Repeat this process for all Side-to-Side Cabinets
and
Modules installed in the same row.
Refer to the next page to see how a Module is ganged to a pair of adjoined Cabinets.
Ganging bolt
Tooth washer
5x
Bottom detailed view of the selected Cabinet:
The
view has been purposely rotated to show the
required hardware to be inserted, same goes for the
second detailed view below.
Nut thigthen
(Opposite) tooth
washer secured
Front detailed view
of the Cabinets
5x
Cabinets legs
