KAYENNE K-FRAME — Installation & Service Manual
139
Engineering Setups
3.
Select the appropriate Output Type:
•
Fixed
if the output is to be dedicated. Later you will be able to select
from either Logical Sources or Fixed Sources for that output.
•
Switched PVW
if the output will be used for switched preview.
Switched preview can be assigned to multiple outputs.
•
Aux
if the output will be an Aux bus (see
for more information).
4.
The
Suite 1
and
Suite 2
buttons are used to assign the currently selected
output to a suite. The default setting is
Suite 1
.
5.
Select an output connector from the list on the right. The change is
immediate and can be viewed on a connected monitor. (Switched
Preview mode does not offer any output sources).
6.
If desired, select the
Output Name
data pad to change the name of the
output using the pop up alphanumeric keypad or standard keyboard.
This name appears on the data pad of the scrolling list on the left. Up to
12 characters can be entered.
Configuring Aux Buses
Aux buses can be used to send dynamically selected sources to an output.
Aux bus sources are selected using the Local Aux panel, delegating an ME
for Aux Bus control, or using Remote Aux Panels delegated to control that
Aux bus.
The number of Aux buses on a Kayenne K-Frame system varies, depending
on how the physical outputs have been mapped. Any output that is not
configured as Fixed or Switched Preview is available for use as an Aux bus.
Summary of Contents for Grass Valley Kayenne K-Frame
