KAYENNE K-FRAME — Installation & Service Manual
117
About Network Configuration
5.
After the Menu Panel restarts, go to
Node Settings, Control Surfaces
. This is
the only GV Switcher menu that will be active when the Menu Panel is
not registered with the Frame.
6.
Enter a descriptive
Node Name
for the Menu Panel, and enter its
IP address
in one of the fields available.
7.
Touch the
Status
subcategory button to exit the menu. A Restart menu
dialog box will appear.
8.
Touch
Restart Now
to restart Menu Panel application.
After restart, the
Status
menu should show the Video Processor Frame, and
the Menu Panel should be fully operational.
About Network Configuration
Grass Valley recommends putting Switcher systems on an isolated internal
network with direct connections from the Control Panels and Menu Panels
to the Video Processor’s internal Ethernet switch.
CAUTION
Grass Valley does
n
ot
recommend putting Switcher systems on a domain
which could expose the control LAN to a WAN or the Internet.
IP Address Background Information
Each device connected to any Ethernet network must have a unique IP
address. An IP address has two components: the network address and the
node address. The Subnet mask defines the dividing line between the two.
The first three octets of Subnet mask provide the network address; the
fourth is the node address. Nodes with the same network address can com-
municate directly with each other, while nodes with different network
addresses normally do not communicate directly.
The Kayenne K-Frame system uses Ethernet switches built into the Video
Processor Frame. The switch provides isolation between port pairs, pro-
viding deterministic communication for panel and frame messaging, and
also allows Control Panel and Menu Panel communication for DPOPs. All
nodes must also have the same network address and be given a different
node address.
Gateway IP Addresses
A gateway IP address can be entered to allow communication with devices
not located on the local Kayenne K-Frame system network. Communica-
tion outside the local network requires using a configured network
gateway server, a description of which is beyond the scope of this docu-
Summary of Contents for Grass Valley Kayenne K-Frame
