KAYENNE K-FRAME — Installation & Service Manual
129
Registering Kayenne K-Frame System Nodes
Control Panel Registration
1.
Touch
Eng Setup
,
Node Settings
,
Control Surfaces
.
2.
Touch an available set of buttons and enter a Node Name and the IP
address of the Control Panel.
3.
You can assign the component to a suite and control surface now if you
wish, but it is recommended to initially configure your Kayenne K-
Frame system as a single suite. Later, you can modify the configuration
for multi-suite operation.
4.
If you want that Control Panel button DPOPs (double press open
button) to affect this Menu Panel, touch
Frame Suite Nodes & ID
and enter
the IP address of that Control Panel in the Track DPOPs from Panel ID
field (see
).
5.
After making an addition or change, you will need to reset the Control
Panel. This can be done two different ways:
•
On the Control Panel Multi-Function Module access the Home
menu, then press
Panl
,
IP
,
Boot
and press
Yes
.
Remote Aux Panel Registration
Note
Do not confuse the Local Aux Panel, which is considered a Control Panel
Stripe, with Remote Aux Panels, which are small panels used to change Aux
Bus sources from a different location. The Local Aux Panel Stripe is not con-
figured with the following menus.
1.
Touch
Eng Setup
,
Node Settings
,
Remote Aux IP Network
.
Summary of Contents for Grass Valley Kayenne K-Frame
