KAYENNE K-FRAME — Installation & Service Manual
239
Software Option Authorization
Enter Permanent Authorization Code
1.
Go to the Install Options menu (
Eng Setup
/
Install Options
) on a Menu
Panel of the system whose options you are enabling (
). Confirm that the System ID on the menu matches the System
ID# of the authorization code.
2.
Touch the
Perm
button in the Option Group pane.
3.
Touch the
New Auth Code for Perm
data pad and enter the code on the pop-
up keypad.
Note
System ID and Authorization Codes are alphanumeric and need to be entered
exactly. Authorization codes do not use the letters “o” or “l” to avoid confu-
sion with the numbers “0” and “1”. The dashes in authorization codes are
required for use.
4.
Touch the button labeled either
Replace
or
Install
next to the new
authorization code. The codes will be added and the expiration date of
any maintenance contract will be indicated. If you do not believe the
option statuses reported are correct, contact Grass Valley Customer
Support to resolve the issue.
5.
If options were removed, reset the Video Processor Frame.
Note
When an option is removed, it remains operational until the Video Processor
Frame is reset or power cycled. When an option is added, it becomes opera-
tional immediately without requiring a Frame reset.
6.
Write down the authorization codes, specifying which system they
apply to, and store this information in a safe place, should you need to
re-enter the codes at some time in the future.
Temporary Authorizations
For demonstration or rental, optional features can be authorized tempo-
rarily. Once you have obtained the temporary authorization code, enter it
on the Kayenne K-Frame system using the procedure described above,
except you first select one of the
Temp
buttons. Temporary authorization
information is displayed on the right portion of the menu. Up to four tem-
porary authorizations are allowed at a time. Temporary authorization fea-
tures that are removed remains active until the Video Processor Frame is
reset.
Control Panel Webpages
Web browser access is available for the K-Frame Control Panels. Using any
web browser able to access the network, type the IP address in the
browser’s Address field to view the Control Panel web pages.
Summary of Contents for Grass Valley Kayenne K-Frame
