KAYENNE K-FRAME — Installation & Service Manual
243
Video Processor Frame Maintenance
you are experiencing problems, you may want to reload the files individu-
ally to help find what might be causing problems.
1.
For troubleshooting, restore your backup files in the following order:
a.
Reload your backup Engineering Setup file and make sure it is
correct by, for example, checking that the proper source names
appear in the Source Definition menu.
b.
Reload a Suite Prefs file and a User Setups file and check that these
settings are correct.
c.
Load some EMEMs and run them to check that they operate
correctly.
2.
If there are any problems with any of the restored files, they may have
become corrupted and need to be deleted and rebuilt. If a problem file
locks the system, you may need to clear NV Memory again to restore
system operation, but you will know what file is responsible. Contact
Grass Valley Customer Support if you need troubleshooting assistance.
Restoring Multiple Suites
If your Kayenne K-Frame system is configured has multiple suites, each
suite will have its own Suite Prefs file. Clearing Video Processor Frame NV
Memory will both suites, so to restore the system completely you will need
to reload Suite Prefs for each suite.
IP Address Information
Storing Video Processor Frame IP address information on the backplane of
the Frame allows control processor board replacement without the need to
enter the IP address of the Frame.
After control processor board replacement you will need to go to the Node
Settings menus (
Eng Setup
,
Node Settings
) and re-enter Panel and Menu IP
addresses (
Control Surfaces
), and Remote Aux information (
Remote Aux IP Net-
work
)
License Information
License information stored on the Video Processor Frame EEPROMS deter-
mine which features are available for use. Licensing is keyed to the serial
number (System ID) for the K-Frame Video Processor.
VP Frame Processor Board Replacement
When replacing the K-Frame Video Processor Frame control processor
board, in either the 6U or 13U K-Frame, verify that the S2 Boot Mode Dip-
switch settings are all in the
UP
or
Normal
position. The dipswitch is located
Summary of Contents for Grass Valley Kayenne K-Frame
