Installation BAT867-F
Release 01 12/2019
27
2.3
Installing the antennas
Install the antennas only indoors.
The device has connections for external antennas. These connections are N
sockets.
On delivery, the connections are sealed with protection caps.
Proceed as follows:
Remove the protection caps from the connections to which you want to
connect external antennas.
Install at least one antenna on the radio module that you would like to use.
Seal an unused socket with a terminating resistor to avoid interferences
from radio signals. The terminating resistor is included in the scope of
delivery for device variants with the Configuration characteristic value "Z"
and available as accessory.
You will find information on setting the transmit power in chapter
the transmit power” on page 35
.
2.4
Connecting the power supply
The supply voltage is electrically isolated from the casing.
WARNING
ELECTRIC SHOCK
Before connecting the electrical wires,
always
verify that the requirements
listed are complied with.
See “Requirements for connecting electrical wires” on page 8.
See “Requirements for connecting the supply voltage” on page 9.
Failure to follow this instruction can result in death, serious injury, or
equipment damage.
Summary of Contents for Hirschmann BAT867-F
Page 53: ...Installation BAT867 F Release 01 12 2019 53...
Page 54: ......
