MACH 100
Release 04 07/10
5
Make sure that the disconnecting device is easily accessible so that
the MACH 100 device can be disconnected from the mains voltage.
If you disconnect the device from the mains voltage using
- the plug in the socket
- an on/off switch
it must be easily accessible.
Hinweis:
For devices with redundant voltage supply (MACH 102-8TP-R,
MACH 102-8TP-FR, MACH 102-24TP-FR), both non-heating appliance
plugs must be pulled to disconnect the device from the main voltage. If the
M1-8TP-RJ45 PoE media module is used, the supply voltage also has to
be switched off or disconnected.
Shielding ground
The shielding ground of the connectable twisted pair lines is connected to
the protective conductor connection via the front panel.
Beware of possible short circuits when connecting a cable section with
conductive shielding braiding.
Housing
Only technicians authorized by the manufacturer are permitted to open
the housing.
The device is grounded via the voltage supply socket.
Make sure that the electrical installation meets local or nationally
applicable safety regulations.
The ventilation slots must not be covered so as to ensure free air
circulation.
The clearance to the ventilation slots of the housing must be at least
10 cm (3.94 in).
Warning!
Never insert sharp objects (small screwdrivers, wires, etc.) into
the inside of the product. There is the risk of an electric shock.
Close all empty slots with a covering panel.
The device must be installed in the horizontal or upright position, either
as a table unit in the switch cabinet
(see fig. 16)
or on the wall
(see
fig. 17)
.
If you are operating the device in a 19" switch cabinet: install sliding/
mounting rails for holding the device
(see fig. 15)
.
Environment
The device may only be operated at the specified maximum ambient
temperature (temperature of the surrounding air at a distance of up to 5
cm (1.97 in) to the device) and relative air humidity.
Summary of Contents for HIRSCHMANN M1-8MM-SXC
Page 48: ......
