11
2 Safety
OZD Profi G12D... ATEX 1 V. 03 07/2014
National regulations applicable for the maintenance/ ser-
vice of electrical equipment in explosion hazard areas
must be complied with.
The required maintenance intervals are application-spe-
cific and hence must be determined depending upon the
operating conditions. As part of maintenance, primarily
parts on which the type of ignition protection is depen-
dent, must be tested (e.g. intactness and tightness of the
housing, integrity of the seals and the cable entries as
well as the required potential equalisation).
If one determines the need for servicing during mainte-
nance, kindly take the “Operation” chapter 1.10, page 10
into consideration.
The devices must not be repaired, changed or manipulat-
ed. In case of defect, the device must be always
replaced by an original one.
Check the packaging and contents for damage. In case of
damage, notify the post and/or the forwarding agent and
the supplier.
Check the delivery scope based on the order and the
delivery documents for completeness and correctness.
Preserve the original packaging. The device should
always be stored or transported in the original packaging.
Always store the device in dry and clean surroundings.
Note the permissible storage temperature (see technical
data, page 54).
1.12 Delivery, Transport and Storage
The devices must not be repaired, changed or manipulat-
ed. In case of defect, the product must be always
replaced by an original one.
1.13 Repairs
The devices and packaging material must be disposed in
accordance with the relevant laws and regulations in the
respective country.
Batteries are not included in the devices, these must be
disposed off separately.
1.14 Disposal
