Instructions for Use
Placement
This free standing stove is designed to be placed on a hard, level surface. When positioning the
stove, keep the following points in mind:
If you are placing the stove in an alcove, make sure that there is at least 150mm of space on all
sides to ensure good air circulation.
The stove must not be located over an electrical mains socket. The mains socket must always
be accessible in order to disconnect the stove from the mains power supply for maintenance or
when replacing a bulb.
Keep hearth rugs and other soft furnishings away from the front of the stove. They could
obstruct the free flow of hot air from the fan and damage both the soft furnishings and the stove.
Operating the Electric Stove
Insert the plug into the mains power supply.
Select the desired function:
Flame effect On/Off (6)
Fan - without heating (3)
Low heat 900w (3+4) or (3+5)
Full heat (3 + 4 + 5)
Heat and Flame effect (1 + 2 + 3 + 4 + 5 + 6)
Increase or decrease the flame effect – rotate higher or lower (2)
The stove will only work if the fan switch (3) is on and the thermostat (1) is set above the
current room temperature.
Caution:
The stove should be free from noticeable vibrations when it is in operation; vibrations
may cause damage to the bulb. Ensure that the stove is turned off before moving it, attempting
maintenance (such as changing bulbs) or cleaning.
Automatic Safety Cut-Off
A safety cut-off switch is fitted to the heating element to prevent damage due to overheating. If
it cuts-off due to an obstruction in the airflow, the stove must be allowed to cool for 15 minutes
and the obstruction must be removed before restarting.
Bulb Replacement
Always unplug the stove from the mains power supply and leave it to cool before attempting to
replace a bulb.
Loosen the three screws at the front of the log bed and remove the fixed plate.
Pull the log bed from both ends to remove it; the two bulbs are located underneath the log bed.
EH0792WK 1800W Boden Electric Stove
6
