10
Operating instructions
1. Connect the pads to the wire by snapping them on, then
remove the protective film.
Note: adding a few drops of water on the pads will increase
their longevity.
2. Place pads where the massage sensations are desired.
And plug into one of the ports on the device. For additional
relief use the second port and repeat steps 1&2 for two
additional pads.
Note: Make sure both pads on the skin and not overlapping.
Make sure your skin is free from any dirt, oil or lotion.
TIPS:
When you use two pads (one channel) or four
pads(two channels) at the same time, make sure you have
placed all the pads on your body, otherwise it won’t work.
3. Turn the device on by pressing the on/ off switch on the
Summary of Contents for AS8015
Page 1: ...1...
Page 14: ...14 Troubleshooting...
Page 15: ...10 This device complies with part 15 of the FCC rules...