Copiscan 8000 Plus Series Operator Manual
www.bellhowell.imagingcomponents.com
August 25, 2000
1-800-SCAN495
55
2. Place a single document that is representative of what you are going to scan in the
feeder tray.
3. Lower the skimmer assembly so that the tray rises.
4. Using your application software, enter a single document scan command according to
the procedure provided by the software manufacturer. The document feeds into the
scanner, where its image is captured and then sent to the host.
5. View the image on the host display. Ensure that the image quality is acceptable. If it
is, adjust the ACE setting according to the procedures found in Section 5.3.3.1,
Setting ACE Image Enhancement
.
6. After you have adjusted the ACE setting, repeat steps 1-5 until you have found an
acceptable setting.
5.5.2 Scanning a Full Batch of Documents
Now that you have set up scanner parameters and made any necessary adjustments, you
are ready to scan a full batch of documents.
Take the following steps to scan a full batch of documents:
NOTE:
Follow all guidelines for setting feeder guides and exit tray guides before you begin
scanning.
1. Lift the skimmer assembly.
2. Place an orderly stack of documents in the feeder tray.
3. Lower the skimmer assembly.
4. Using your application software, enter a SCAN TO BATCH (or a similarly worded)
command according to the procedure provided by the software manufacturer. The
documents feed into the scanner, where their images are captured and then sent to the
host.
5. When the batch is finished scanning, remove the documents from the exit tray.
5.6 Multifeed
Detector
The multifeed detector picks up an ultrasonic signal that determines when there is more
than one sheet of paper entering the scanner.