Copiscan 8000 Plus Series Operator Manual
www.bellhowell.imagingcomponents.com
August 25, 2000
1-800-SCAN495
65
Take the following steps to clean the page sensors:
1. Turn OFF the scanner.
2. Remove any documents in the exit tray.
3. Open the transport with the lift-handle on the lower right side of the control panel,
opening as high as it will rise.
CAUTION:
Do not touch the page sensors with cotton swabs (or anything else) when cleaning
them. Use the transport cleaner only.
CAUTION:
Do not turn the sensor and transport cleaner (Maintenance Kit Item #4) can upside
down while using.
4. Clean the front sensors of the scanner using the sensor and transport cleaner
(Maintenance Kit Item #4). Direct the nozzle toward each of the sensors as shown in
the figures below. There are five pairs of sensors in the entry section, located behind
the holes in the stainless transport plate at the front of the scanner.
Figure 41. Entry Page Transmit Sensor Locations