Infinity WF Operator Manual
Page 114 of
117
S008459 Rev C
11. The IP address of the scanner will be the factory default value of 192.168.1.50
12. Change the network parameters to the values which were used before running the recovery
sequence (refer to the second bullet item in
Before Recovering to Factory Defaults
(IMPORTANT)
above)
13. Reboot the scanner when prompted
14. Reconnect to the scanner using the new IP address
15. Update the scanner’s firmware (refer to the third bullet item in
Before Recovering to Factory
Defaults (IMPORTANT)
above)
16. After the firmware update, all software adjustments for the scanner must be performed (refer
to the last bullet item in
Before Recovering to Factory Defaults (IMPORTANT)
above)
17. When the recovery sequence has finished, the scanner will power OFF automatically