INTUITY CONVERSANT System Version 6.0
MAP/100 New System Installation
585-310-176
Issue 3.0
June 1997
Unpacking the MAP/100 and Installing Nonassembled Hardware
Page 2-5
Installing the Cable Tie-Down Bracket
2
9. Gently snap the split ferrite core toroid shut around the cable (
).
10. Attach a cable tie directly behind the split ferrite core toroid to secure it.
11. Cut and remove the excess cable tie.
Installing the Cable Tie-Down Bracket
Each MAP/100 includes a cable tie-down bracket. Units equipped with multiple
Tip/Ring circuit cards and a Tip/Ring distribution panel are shipped with cabling
attached to this bracket. This bracket must be permanently attached to the unit. If
it is not, see
for an example of the position of the bracket during
shipping.
To install the cable tie-down bracket:
1. Loosen the four screws next to the 25-slot backplane (
2. Slide the bracket under the screw heads in the slots provided (
).
3. Tighten the screws.
MAP/100s, configured without the Tip/Ring distribution panel, ship with the cable
tie-down bracket located on the bottom of the shipping carton. It is
recommended that you install the bracket as described above and use it as a
cable strain relief for all external I/O cabling.