1. During Standby mode, press the PLAY button on base unit to start playback of the
message(s);
2. To repeat the current message, press the PREV. button on base unit to go the beginning of
the current message; Press the PREV. button quickly again will skip to the previous
message;
3. To skip to next message, press the SKIP button on base unit;
4. To erase the current message, press the ERASE button on the base unit;
5. To erase all old message(s), press and hold the ERASE button on the base unit;
6. To stop the message playback, press the STOP button on base unit.
7. To change volume of playback, press the VOL.UP or VOL.DOWN button to change the
volume to desired level, the 7-segment LEDs shows “L1”, “L2”, … “L8” as speaker volume
indication.
HANDSET REMOTE MODE
You can listen to the message and turn answerer on/off using handset by entering the handset
remote mode.
1. During Standby mode, press the REMOTE button on handset to enter the remote mode,
the LCD shows “
ANSWERER REMOTE ACCESS MODE
”;
2. You can press 2 to playback the message as operating the base unit;
3. During playback, press 1 will goes to beginning of current message and quickly press again
will goes to previous message, or press 3 to goes to next message, or press 0 to erase
current message;
4. At the beginning of the remote mode or after the stop of message playback, you will hear
the voice menu “For help menu, press 7; To turn answer off on, press 4; To playback,
press 2; To stop, press 2 again; During playback, to skip to next message, press 3; To skip
to the previous, press 1; To delete, press 0”.
5. During remote mode, you can press 4 to turn answer on/off and hear the voice prompt
“Answer on” or “Answer off” for indication;
6. During remote mode, you can press 7 to hear the voice menu again.
LINE REMOTE MODE
You can call to your answerer from a remote tone telephone. Answerer will answer the call
after the preset ring count. (either 3, 5, or 10 rings)
1. When the answerer answering the call, enter your 3 digits PIN code to engage the line
remote mode. If the answerer does not prompts you the voice menu, that mean some
tone code cannot be correctly received, please re-enter the PIN code again within
8seconds timeout period, you may need to enter * before the PIN to force the
answerer to start over the reception of PIN code sequence.
2. At the beginning of the remote mode, you will hear the voice menu, same voice menu
as in handset remote mode, please refer to the tone command described in
HANDSET REMOTE MODE section for detail. (you may turn answer on/off, playback
message, erase message)
3. If the answerer cannot receive your next command within 8 seconds timeout counting
from the end of completion of previous command, it will disconnect your call.
4. If you disconnect the call, the answerer will disconnect after 8 seconds.
INCOMING CALL SCREENING
When there comes an incoming call, you can let the answerer take the call for you. On the
other hand you press the REMOTE button on handset to enter call screening mode 3 seconds
after the answerer answers the call, screen will shows “
CALL SCREENING
” and you can
listen to the caller from the handset receiver while the caller don’t known that the call is being
