FCC NOTICE
The FCC requires that you be advised of certain requirements involving the use of this
telephone.
1.
This telephone is Hearing Aid Compatible.
2.
This equipment complies with Part 68 of the FCC rules and the requirements adopted by
the ACTA. On the
bottom
of this equipment is a label that contains, among other
information, a product identifier in the format
US:AAAEQ##TXXXX.
If requested, this
number must be provided to the telephone company.
3.
The REN is useful to determine the quantity of devices you may connect to your telephone
line and still have all of those devices ring when your number is called. In most, but not all
areas, the sum of the RENs of all devices should not exceed five (5.0). To be certain of
the number of devices that you may connect to your line, as determined by the REN, you
should call your local telephone company to determine the maximum REN for your calling
area.
4.
To maintain compliance with the FCC’s RF exposure guidelines, place the base unit at
least 20cm from nearby persons.
5.
If your telephone causes harm to the telephone network, the telephone company may
discontinue your service temporarily. If possible, they will notify you in advance. But if
advance notice is not practical, you will be notified as soon as possible. You will be
advised of your right to file a complaint with the FCC.
6.
Your telephone company may make changes to its facilities, equipment, operations or
procedures that could affect the proper operation of your equipment. If they do, you will be
given advance notice so as to give you an opportunity to maintain uninterrupted service.
7.
If you experience trouble with the telephone, please contact VTC Service & Manufacturing
Co., Inc. at (800) 888-8990 or write to: VTC Customer Service, 16988 Gale Ave., City of
Industry, CA 91745 for repair/warranty information. The telephone company may ask you
to disconnect this equipment from the network until the problem has been corrected or you
are sure that the equipment is not malfunctioning.
8.
This equipment may not be used on coin service provided by the telephone company.
Connection to party line service is subject to state tariffs.(Contact your state public utility
commission or corporation commission for information).
9.
WARNING:
Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user’s authority to operate the equipment.
NOTE:
This equipment has been tested and found, complies with the limits for a class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in residential installation. This
equipment generates, uses and can radiate radio frequency energy. If not installed and
used in accordance with the instruction, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measure:
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the
receiver needed.
•
Consult the dealer of an experienced radio / TV technician for help.
10. USOC jack type is RJ11C and the compatible jack is Part 68 compliance.
11. An applicable certification jacks Universal Service Order Codes (USOC) for the equipment
is provided (i.e.,
RJ11C
) in the packaging with each piece of approved terminal
equipment.
12.
NOTICE:
If your home has specially wired alarm equipment connected to the telephone
line, ensure the installation of this
[equipment ID]
does not disable your alarm equipment.
If you have questions about what will disable alarm equipment, consult your telephone
company or a qualified installer
