Bell Phones Excursion 36240, Owner'S Manual

36240 English I/B version 11259B-1

 11259B-1                                                                                                                                              14

     OWNER

＿

＿

S MANUAL#

36240 

VER. 11259B-1 

PAGE:   

14

    English Canadian Version 

2.   Start your conversation. 
3.   To end your conversation, either press the TALK button or place the handset on 

the base unit. The base IN USE LED indicator will turn off.  

LAST NUMBER REDIAL

A.  AFTER HEARING A BUSY TONE WHEN PLACING A CALL 

1. 

If you get a busy tone, press handset TALK button to hang up. 

2. 

Press the handset TALK button again and listen for a dial tone. 

3. 

Press the handset RE/PA button. This will automatically  

        redial the last telephone number you called (Up to 24 digits).         

B.  WHEN THE HANDSET IS OFF THE BASE UNIT AND IN STANDBY MODE

1. 

Press the TALK button on the handset and listen for a dial tone. 

2. 

Press the RE/PA button. This will automatically redial the last telephone number 
you called (Up to 24 digits).  

NOTE: 

When the adapter power is disconnected and connected again, the unit can 

not redial the last telephone number you called.

MEMORY DIALING

You can store up to 10 telephone numbers (up to 16 digits each) into memory and you 
can then dial any of the stored phone numbers.  

A.  STORING TELEPHONE NUMBERS INTO MEMORY

1. 

Make sure that the handset is in the standby mode. The base and handset IN 
USE LED indicator should be OFF. 

2. 

Press and release the MEMO button. The handset will beep once. 

3. 

Enter the telephone number you want to store (maximum of 16 digits). A key tone 
is heard for every key pressed. 

4. 

Press the MEMO button once again. 

5. 

Press a number (0 through 9) where you want to store the phone number. 

You will hear a long beep to confirm that the number was properly stored. 
6. 

Repeat procedures 1 to 5 to store other telephone numbers. 

B.  RECALLING A TELEPHONE NUMBER FROM MEMORY 

1.   Press the TALK button. 
2.   Press the MEMO button.

3.   Select and press one of the keypad buttons (0 to 9). The  stored telephone 

number will be dialed automatically.

C.  CHANGING STORED TELEPHONE NUMBERS

• 

Follow the steps described in  toring Telephone Numbers. The new phone 
number will automatically replace the previous one. 

MIXED MODE DIALING (Temporary Pulse to Tone Dialing)

1.    If you only have pulse (rotary dialing) service in your area and want to access 

Tone services (Bank by Phone, etc.), ensure that the Tone / Pulse switch is set 
to the Pulse position. 

2.    Press the TONE ( 

*

 ) button once to switch from Pulse to Tone dialing