36240 English I/B version 11259B-1
17 11259B-1
OWNER
＿
＿
S MANUAL#
36240
VER. 11259B-1
PAGE:
17
English version
maximum charge.
4.
The Excursion
®
36240 is now ready for regular use. Discharge and charge the Ni-
Cd battery again once you notice
a decrease in the useable charge time.
MAINTENANCE
1.
Your phone should be situated away from heat sources such as radiators,
heaters, stoves or any other appliance that produces heat.
2.
Use a slightly damp cloth to clean the plastic cabinet. A mild soap will help to
remove grease or oil. Never use polish,
solvents, abrasives or strong detergents
since these can damage the finish.
TROUBLESHOOTING
SYMPTOMS
POSSIBLE SOLUTION / CAUSE
No dial tone
•
Check for the telephone line cord connectors at both
ends that they are pushed in firmly until they click.
•
Check if another telephone line (sharing with the same
line as the Excursion
®
36240) is off-hook or in use.
•
If you had a power failure or had unplugged the base
unit, replace the handset on the base unit for two to five
seconds to reset the system.
Does not ring
•
Check the ringer mode on the handset. Change to RING
ON mode to enable the handset ringer.
•
Check for the telephone line cord connectors at both
ends that they are pushed in firmly until they click.
•
You may have exceeded the Ringer Equivalence Number
(REN) limit of how many phones can be connected to
the same line. The REN total of all devices (printed on
the bottom label of each unit) should not exceed five (5).
Disconnect the appropriate units to lower the REN total.
No power on the
handset unit
•
Check for the Ni -Cd battery pack for proper connection
inside the battery compartment on the handset.
•
The handset rechargeable Ni-Cd battery pack may need
charging.
Does not charge
•
Check for the Ni -Cd battery pack for proper connection
inside the battery compartment on the handset.
•
The charging contacts and terminals may need cleaning
with an alcohol-dampened swab.
Range is limited
•
Move the base unit so that it is centrally located in your
residence or office and make sure that the base unit is
not located near appliances.
•
The handset Ni-Cd battery may be weak. Recharge the
Ni-Cd battery.
•
Refer to the section "Improving Cordless Reception".
Interference on
reception
•
Choose an alternate channel using the SCAN button on
the handset.
•
Refer to the section "Improving Cordless Reception".
