Tone/Pulse Switch
1. Select the dialing mode, either Tone or
Pulse, by setting the switch on the
bottom of the base unit.
Note:
Changes to the switch position
during a call do not take affect until
the call has ended.
Tip:
If you are unsure of the proper dialing mode, make a trial call with the switch set
to
Tone
. If the call connects, leave the switch as is. Otherwise, set it to
Pulse
.
Wall Mounting
The BE-3872 telephone may be installed onto two screws (not included)
fastened into the wall. When installing screws into plasterboard walls, use wall
anchors (not included) to ensure that the screws remain secure. Insert the
screws into the wall leaving 3/16" of each screw extending out from the wall.
See the wall mount template on page 33 to properly space the screws in the
wall for mounting. The BE-3872 is not compatible with mounting on a standard
telephone wall plate.
Wall Mounting Instructions:
1. Remove the handset from the base.
2. Adjust the base to the wall mount
position (see illustration).
3. Plug the supplied 7-foot telephone cord
into the
LINE
jack on the telephone.
4. Connect the telephone line cord to the
wall jack.
5. Insert the AC adapter into the
9V DC
jack on the top of the base.
6. Run the cables down through the cable
channel to allow for flush wall mounting.
7. Slip the telephone base onto the wall, lining up the wall mounting holes over
the screws. Slide the telephone base down so it is firmly in place.
8. Return the handset to the telephone base.
9. Plug the other end of the AC adapter into the AC outlet.
14
TELEPHONE SETUP
Connecting the Base
1. Remove the battery
compartment cover located on
the base bottom.
2. Install a 9V backup battery (not
included) into the battery
compartment as shown and
replace the battery
compartment cover.
3. Connect the telephone line cord to the
"LINE"
jack and to a telephone outlet.
4. Connect the AC power adapter to the 9V DC jack and to an AC outlet. Wait
15 seconds for the answering system to reset before using the telephone.
Note:
Use only the supplied AC power adapter. Connect the AC power adapter
to a continuous power supply. Place the phone close to the AC outlet so
that you can plug in the AC power adapter easily.
Tip:
If your telephone outlet is not modular, contact your telephone company for
assistance.
Handset Ringer Volume
Adjust the handset ringer volume using the RINGER
switch on the right side of the handset. Select
between Hi ringer, Low ringer, and ringer Off.
TELEPHONE SETUP
13
Ring
er
Off Lo
w Hi
Ringer Switch
!
Tone/Pulse Switch
