ISS
1,
SECTION
574-504-720
To remove punch transport assembly:
retainer ring
(119652)
and shim.
retainer ring
(119649)
spacer and felt washer
(93758)
from upper end of eccentric drive arm.
@)
Loosen cabl� clamp screw and free
transport coil cable from clamp.
Loosen setscrew on eccentric drive
and remove assembly.
Note:
When replacing, align setscrew
with
countersunk hole in shaft before tightening.
To remove reader transport assembly:
s
Remove
"0"
ring belt.
transport connector.
The transport can now be removed
if
necessary.
retainer ring
(119652)
and shim.
Loosen cable clamp screw and free transport coil cable from clamp.
transport connector
from circuit card on underside
of reader housing. The transport
can now be removed if necessary.
Pag
e
7
