SECTION 502-612-410
Install the wiring board and plug assembly as
follows:
(1) Remove set housing.
(2) Loosen screws on dial mounting plate, move
mounting to left and lift out.
(3) Remove right-hand dial mounting screw.
(4) Place dial mounting screw through hole
m
wiring board and replace screw in dial.
(5) Connect plug assembly to chaining switch
of third module (2636-type) or fifth module
(2637-type) and terminate (G-V) and (V-G) leads
of plug (Fig. 3). Insulate and store unused plug
leads.
(6) Replace and secure dial mounting plate.
Note:
If more than one busy lamp is required,
order a 6C KTU and use busy lamp control
circuit as shown in Fig. 5.
2.09
A D-180411 Kit of Parts is required when
Priority Hold
is to be furnished. Install
as follows:
(1) Assemble kit of parts by connecting contact
strips to 635A5C key. Install pink plug in
hold position on key.
(2) Disconnect all mounting cord plugs and the
two contact strips [sets equipped with D120K
(MD) or D200S (MD) mounting cord] from the
..
Page 2
key in the second module. Remove key and
replace with 635A5C key from kit of parts.
(3) Reterminate contact strip leads and connect
mounting cord plugs, with the exception of
the white plug which is insulated and stored.
Note:
Contact strips are not required with
sets equipped with Dl20M or D200AA mounting
cords.
(4) Rearrange wiring per Fig. 4.
Hold key in first module is used as regular hold
and if required
I Hold.
Second hold key is used
for
Priority Hold.
2.10
When required, these sets may be equipped
with a polarity guard. Polarity guards
should be installed only when specified by local
instructions for end-to-end signaling purposes when
battery and ground reversals are encountered. A
P-90Dl97 guard assembly must be separately ordered
and connected as shown in Table E.
3.
MAINTENANCE
3.01
For maintenance information, refer to Division
502, section entitled 630, 1630, and 2630
Series Telephone Sets - Common Installation and
Maintenance Information. Individual components
such as dials, keys, ringers, etc. are covered in
sections pertaining to the particular item.
3.02
Do not use solvents to clean plastic parts
of these sets. Use a damp cloth only. If
discolored, replace part .
SSP
502·612-410-i04_197S-03-02.jpg Scanned by Frank
Harrell,
(Cowboy Frank) Castle Rock, Colorado Feb 04,2012 16:18:58
