H1C0091SNB/H1C009WSNB
Bellagio By Airworks
12. To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not use on soft surfaces,
like a bed, where openings may become blocked.
13. A heater has hot or arcing or sparking pads inside. Do not use it in areas where gasoline, paint or
flammable liquids are used or stored.
14. Use this heater only as described in this manual. Any other use not recommended by the manufacturer
may cause fire, electric shock, injury to persons or other damage to property.
15. To prevent overload and blown fuses, be sure that no other appliance is plugged into the
same outlet (receptacle) or into another outlet (receptacle) wired into the same circuit.
16. It is normal for the heater’s plug and cord to feel warm to the touch. A plug or cord which becomes hot to
the touch or becomes distorted in shape may be a result of a worn electrical outlet. Worn outlets or
receptacles should be replaced prior to further use of the heater. Plugging heater into a worn outlet/
receptacle may result in overheating of the power cord or fire.
17. Ensure the heater is on a stable, secure surface to eliminate the potential of tipping it over.
18. We do not recommend use of an extension cord as it may overheat and cause a risk of fire. However, if
you have to use an extension cord, the cord should be No.14 AWG minimum size and rated not less than
1875 watts, and has to be used only for supplying power to this heater. The cord should be as short as
possible (long cords coiled up can overheat, as well as cause tripping accidents) and not used to supply
power with more than one appliance at a time.
19. Be sure that the plug is fully inserted into appropriate receptacle. Please remember that receptacles also
deteriorate due to aging and continuous use: check periodically for signs of overheating or deformations
evidenced by the plug. Should this occur, do not use the receptacle and CALL your electrician.
20. Check that neither the appliance nor the power cable has been damaged in any way during transportation.
21. Make sure that no pieces of polystyrene or other packaging material have been left between one element
of the appliance and another. It may be necessary to pass over the appliance with a vacuum cleaner.
22. When switching on the appliance for the first time, you may notice a slight odour which is normal with new
electrical appliances. Allow odour to dissipate by running appliance at full power for about ten minutes.
Make sure that the room in which the appliance is located is well ventilated during this operation. This
heater draws 12.5 amps during operation. To prevent overloading a circuit, do not plug the heater into a
circuit that already has other appliances working.
23. Do not run in locations when the heater will be left unattended for long periods of time. (For example - in
an unoccupied summer cottage).
24. Do not use attachments or filters. They are not recommended.
CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY
INSERT.
FOR HOUSEHOLD USE ONLY
SAVE THESE INSTRUCTIONS
