08
07
Installation Process
Installation Process
3. .
Seal the gap between the bathtub side and the wall with sealant, to avoid water leakage
Usage
1. Switch on the power supply.
2. Turn on the cold/hot water switch, and adjust to the suitable temperature. Use the switch
to choose the faucet or handheld shower to let water in.
3. Don't press the pneumatic switch unless the water level in the bathtub goes beyond the
jets position.
4. Use air regulator to adjust the massage power.
5. Rotate the handheld shower to adjust the massage effect.
6. Use light switch to turn on/off the underwater light.
7. Adjust the water divider to use back jets or bottom jets. When the divider handle is in the
middle position, you can use both back jets and bottom jets at the same time.
8. Press pneumatic switch, turn off the pumps, and drain the water after use.
9. Turn off the power supply.
Troubleshooting
Trouble
Possible Reason
Try this to solve
Water pump
Don't work.
Power supply is not well connected,
the creepage protector disconnect .
Turn on the power supply, and connect
the creepage protector.
Clean the water pump impeller.
Water pump impeller was stuck
by sundries.
Press the water pump switch.
The water pump switch is off.
Plug the power supply in.
Power supply plug don't insert or no
enough power supply.
Repair or replace the water pump.
Water pump trouble.
Air pump don't
work.
(this version
include )
don't
No enough power supply.
Check the circuitry and plug the power
supply in.
Press the air pump switch.
Switch is off.
Plug the power supply in.
Power supply plug don't insert or the
power supply is abnormal.
Massage power
can't be adjusted.
Voltage problem.
Check voltage.
Adjust switch is off or has problemis
broken.
Water Circulation is blocked.
Check, replace the switch.
Clean the water circulation.
Bathtub don't
stand horizontally.
Adjustable foot is not well-adjusted.
Adjust the Adjustable foot.
Water leakage.
Obturating ring is not good.
Replace the obturating ring.
Nut is loose.
Connect part is not well connected.
Screw down the nut.
Pay attention to the connect part
conglutination.
Summary of Contents for MT-IR1802
Page 1: ...MT IR1802 ...
