14
BellAire™ Model 7000 Tire Inflator Instructions
TROUBLE SHOOTING
MAINTENANCE
The inflator fails to run with the inflator power switch turned on or digital pressure gauge does not illuminate:
•
Check that the inflator’s main power switch is also on. See #1 in figure 1, page 3.
•
Check that the plug is fully inserted into 12 Volt cigarette lighter socket. See operation instructions on pages 5-13.
•
Your vehicle may require the ignition be turned to the accessory position for the cigarette lighter to have power. The
inflator should be used with the vehicle running.
•
Check to see if the main fuse or if the fuse in the 12 Volt lighter plug has blown. See fuse replacement instructions in
the maintenance section. See figure 6 & 7, above.
•
If using the internal battery for power, make certain the green battery level indicator is on. If not, see “Rechargeable
Battery Cautions” section on page 4 and “Battery Indicator Light Chart” section on page 5.
Inflator fails to stop at the auto shut-off pre-set pressure:
•
Check to make sure auto shut-off pressure settings are being set correctly. See operation instructions on pages 5-13.
•
Check that the correct pre-set pressure has been set.
12 Volt power cord gets hot:
•
Make certain power cord is not coiled up or in a knot or damaged.
1.
Your BellAire™ 7000 has two replaceable fuses providing maximum protection for the inflator and/or your vehicle.
See figures 6 and 7 for fuse replacement instructions.
2.
Regularly check inflator air hose, 12 Volt cord and adapters for damage.
3.
Always keep the inflator in its carry case if not wall mounted.
4.
Keep the inflator dry, clean and free from oil and grease. Always use a clean cloth when cleaning.
FIGURE 7
—
12 Volt Adapter Fuse Replacement
Turn tip counterclockwise to unlock Fuse Adapter Body
Fuse
(Replace with ACG glass 15 amp fuse only)
Adapter Body
FIGURE 6
—
Main Fuse Replacement
Main Fuse
(Replace with 15 amp blade type fuse only)
7.
Turn off the inflator power switch to stop inflator when the inflatable item has been adequately deflated.
8.
Remove raft air hose nozzle from inflatable and return raft air hose to its storage location.
9.
Turn off the inflator main power switch.
10. Properly store your tire inflator in the carry bag provided.
USING THE LED WORK LIGHT
1.
The (6) LED work light is located on the front lower edge of the inflator (see #13 in figure 1, page 3) and is operated
with a separate light switch. See #3 in figure 1. The light can be used by itself or used while inflating or deflating to
illuminate the work area.
2.
The main power switch must be on in order for the work light to have power. See #1 in figure 1.
3.
The work light is powered in either 12 Volt DC power or internal battery power mode.
4.
The work light rotates for best directional lighting of your work area.