17
Service & Maintenance
Assembly of the Control Pump
1. Carefully clean the housing with compressed air on the inside. Check for scratches on sliding bores for O Rings and there are
no sharp edges.
2. Press the Bushing in to Housing.
3. Lubricate the Lip Seal with Hydraulic Oil and slip it on the Rack (open side away from the rack).
4. Lubricate the Rack with Hydraulic Oil and slide it into the Housing until the
Lip Seal is in the groove, making sure the teeth are
in the right position. When the Lip Seal is in the Groove this represents forward motion.
5. After lubricating the Pinion (without O Rings), insert it into the Housing and Rack. Check the movement of the Rack from Forward
to Reverse. (See
CAUTION
).
6 Take the Pinion out and fi t the two O Rings, making sure they are not damaged.
7. Lubricate the Pinion and O Rings with hydraulic oil and carefully insert in to the Housing. Make sure the Rack is in the right
position and this is easiest when in reverse motion.
8. Fit the Shim and Retaining Ring. It may be necessary to push the Pinion from the opposite side to get them assembled.
9. Place the Housing on the fi ller side and fi t the O Rings to the bottom face.
LOCTITE seal 518
is recommended.
10. Assemble the Hydraulic Connector and Dowty Washer using
LOCTITE 243.
11. Assemble the Bracket and fi x with 4 screws and washers using
LOCTITE 243.
12. Loosely fi t the Plug Screw and Washer
DO NOT TIGHTEN.
Warranty
Your new Belle Group ‘RPC’ plate compactor is warranted to the original purchaser for a period of one-year (12 months) from the origi-
nal date of purchase.
The Belle Group warranty is against defects in design, materials and workmanship.
The following are not covered under the Belle Group warranty:
1. Damage caused by abuse, misuse, dropping or other similar damage caused by or as a result of failure to follow assembly,
operation or user maintenance instructions.
2. Alterations, additions or repairs carried out by persons other than Belle Group or their recognised agents.
3. Transportation or shipment costs to and from Belle Group or their recognised agents, for repair or assessment against a
warranty claim, on any machine.
4. Materials and/or labour costs to renew, repair or replace components due to fair wear and tear.
The following components are not covered by warranty.
•
Drivebelt/s
•
Engine Air Filter
•
Engine Spark Plug
Belle Group and/or their recognised agents, directors, employees or insurers will not be held liable for consequential or other damages,
losses or expenses in connection with or by reason of or the inability to use the machine for any purpose.
Warranty Claims
All warranty claims should fi rstly be directed to Belle Group or Belle Group Inc., either by telephone, by Fax, by E-mail, or in writing.
For Warranty claims:
Belle Group Inc.
3959 Electric Road, Roanoke
VA, 24018
USA
Tel: +1 540.345.5090
Fax: +1 540.345.5091
E-mail: Bellegroupinc@aol.com
In reverse motion the Control Handles run parallel with the Housing in the direction of the operator.
CAUTION
