35
Connect to the gas supply
The inlet to the cooker is
1
⁄
2
” BSP
internal situated at the rear centre.
Use a 900mm - 1125mm length of
flexible connector.
Ensure that all pipe work is of the
correct rating for both size and
temperature.
Natural Gas -
Flexible connections
should comply with BS 669. Parts of
the appliance likely to come into
contact with a flexible connector have
a temperature rise of less than 70˚C.
After installation, make sure all
connections are gas sound.
Important:
- ensure that you route
all mains and electrical cables and
flexible tubing well clear of any
adjacent heat source.
Commissioning
Burner aeration
All burners have fixed aeration and no
adjustment is possible.
Pressure setting
G20 Natural Gas @ 20 mbar
Ignition
All burners are ignited by pressing the
ignition switch on the facia. When the
burner has lit release the ignition
switch. Turn the tap to the
FULL ON
position, wait a second before
pressing the ignition switch.
Before leaving the installation
1. Place all the loose parts of the
cooker into position.
2. Show the customer how to operate
the cooker and give them this
handbook.
Thank you.
Installation Instructions