InstallatIon InstRUctIons - Gas
levellInG yoUR cooKeR
place a spirit level on a baking sheet onto
an oven shelf.
The cooker is fitted with LEVELLING
feet.
level your cooker to your desired
height using the levelling feet at the front
and rear of the cooker.
stability bracket
If the cooker is fitted with a flexible con
-
nection, a stability bracket should be fit
-
ted to engage in the back of the cooker. A
stability bracket can be bought from your
local supplier.
A stability bracket can be fitted as follows:
place the cooker in position and draw a
pENcIl lINE level with the front edge
(2).
Mark the centre of the cooker to give a
cENTrE lINE (3).
remove the cooker and mark off 200mm
to the right of the centre line (4) on the
rear wall.
Measure from Floor lEVEl to the
ENGAGEMENT EdGE where the stability
bracket will rest and add 2mm (5).
Transfer this dimension to the rear wall
and secure the bracket to the wall at this
height (6) using the two off centre holes
in the single bracket.
