7
5. INSTALLATION INSTRUCTIONS
FIG. 4
FIG. 5
FIG. 6
A
B
C
D
E
553 473 67.5 59.5
175
min.
UNPACKING THE APPLIANCE
Remove all packaging before use and check to make sure that the appliance is in perfect condition. If you
have any doubts do not use the appliance and call your supplier.
Some parts on the appliance are protected by a plastic film. This protective film must be removed
before the appliance is used. We recommend carefully slitting the plastic film along the edges with a
sharp knife or pin.
The packaging materials should carefully discarded and not left within easy reach of children as
they are a potential safety hazard.
INSTALLING AND FIXING THE HOB
Your hob can be fitted to any worktop with a thickness of 30 to 40 mm.
No overhanging surface or cooker hood should be closer to the hotplate than 750 mm (29
1/2"
). Fix in position
in accordance with fig. 4. If fitting a 600 mm bridging unit above the hob unit, the sides of adjacent cabinets
may be lower than 750 mm, down to 336 mm depending on the cabinets fitted, provided that they are
resistant to heat and steam.
The hob has a special seal which prevents liquid from entering the cabinet. Follow these instructions in order
to correctly apply this seal:
- Detach the seals from their backing, checking that the transparent protection still adheres to the seal itself.
- Turn over the hob and correctly position seal “E” (fig. 5) under the edge of the hob itself, so that the outer
part of the seal itself perfectly matches the outer edge of the hob. The ends of the strips must fit together
without overlapping.
- Evenly and securely fix the seal to the hob, pressing it firmly in place.
- Remove the strip of protective paper from the seal. Insert the hooks “S” into their relative housings “H” on
the hob and place into the prepared hole in the cabinet. Lock in place with the relative fixing screws “F”
(see fig. 6).
