1234567890
1234567890
1234567890
1234567890
1234567890
1234567890
1234567890
GB
16
7.2 CLEANING OF FILTERS
After each wash the filter group should be checked in order to remove possible dirt residues. Proceed
as follows:
• take out the central filter 1.
• remove the external water filter 2.
• take out mobile grid 3.
Clean these components under running water. It is important to clean all filters thoroughly. (The
dishwasher cannot function properly with obstructed filters.)
To avoid damage to the wash pumps, it is recommended that the filters are replaced back in their
positions immediately after cleaning.
LA2505-180
21
LA2505-190
22
LA2505-200
23
2
3
1
7.3 CLEANING OF THE DISHWASHER’S EXTERNAL SURFACES
The dishwasher’s surfaces (metal with a plastic front) must be cleaned periodically. Use a clean and
soft piece of fabric. Never use acids or abrasive detergents.
If you don’t use the appliance for long periods of time
If the dishwasher is not being used for extended periods of time, you should proceed as follows:
• run the pre-wash programme twice
• remove the electric plug from the outlet
• disconnect the water supply tube
• leave the door slightly open to avoid the formation of bad odours.
7.4 TABLE OF ERROR CODES
Action to be taken
- Reset the dishwasher
- Check
- Reset the dishwasher
- Call the authorised assistance centre
- Reset the dishwasher
- Verify the water pressure
- If the same problem reoccurs, contact the authorised
technical assistance centre immediately communica-
ting to them the type of error that is shown.
- Verify the water pressure
- Call the authorised assistance centre
- Check
- Check
- Call the authorised assistance centre
- Clean the filter grills
- Check at the end of the cycle, position the pots
correctly during the next wash
- If the same problem reoccurs, contact the authorised
technical assistance centre
Checks to carry out
- Tap closed
- Filter of loading tube blocked
- Drainage tube flat
- Drainage tube broken
- Water supply tube bent
- Insufficient water pressure
- Repeat the washing cycle
- Insufficient water pressure
- The litre counter valve is not working
- The drainage tube is bent
- The siphon is blocked
- The drainage pump is blocked
- The filter grills are blocked
- A pot is placed up side down
- Repeat the washing cycle
When this occurs
During the water cycle
(the program stops)
At the end
of the cycle
At the end
of the cycle
At the end
of the cycle
At the end
of the cycle
At the end
of the cycle
Error
E1
E2
E4
E5
E6
E7
N.B.: Upon contacting the authorised technical assistance centre always communicate the type of error encountered.
