how to use the appliance
Automatic ignition with flame failure safety device
To ignite a burner:
o
Press in the control knob of the burner that you wish to light and turn it
anti-clockwise to the maximum position.
o
If you keep the control knob depressed, the automatic ignition for the
burner will operate.
o
You should hold down the control knob for 15 seconds after the flame on
the burner has lit. If after 15s the burner has not lit, stop operating the
device or wait at least 1 min before
attempting a further ignition of the burner.
o
After this 15-second interval, to regulate the flame you should continue
turning the control knob anti-clockwise until the flame is at a suitable level.
The operating position MUST be at a position between the maximum and
minimum position.
o
To switch the burner off, turn the control knob fully clockwise to the gas off
position.
o
In the event of a power failure the electronic ignition will not function , but you
can light the gas burners in this instance with a match or separate gas ignition
device.
GSM Retail Australia
Pty Ltd ABN: 53 007 582 475
For Warranty and technical queries: 1300 373 199 Aust OR 0508123108 NZ www.belliniappliances.com.au
Model No. BGM604, BGM604-F Only In Builders Pack BP370EG FINELINE: 5103600 Aus 60cm 4 Burner Gas Cooktop
11
