6
Operation
Start operation
1.
Clean storage compartment
Before switching appliance On, give the storage compartment a clean to remove any dust
deposits, at the same time check that drainage pipe is satisfactorily connected .
（
For
details, please refer to the “Maintenance and cleaning”
）
2.
Let appliance settle after installation
Before switching the appliance On, allow refrigerant to settle first for at least 30 Minutes
after installation.
3. Power on
Switch appliance On,allow it to operate for a minimum of 1 Hour and than check
that the appliance has actually cooled, if all OK you can now place your wine
bottles into the appliance .
Control panel
All keys
are not active with the appliance
in lock mode. Please unlock first.
ON/OFF
1.
Press and hold ON/OFF Key for 3 seconds to activate appliance to go in stand-by mode
2.
Press ON/OFF key again for 3 seconds to unlock from stand-by mode back to
operation mode.
Light
Press light Key to activate or deactivate LED light inside storage compartment.
In stand-by mode this operation cannot be actioned.
Zone switch
Press this key to select and switch between Upper and Lower compartment
zones to set the desired temperature for the selected zone.
Press key once, the LED Display will flash, indicating that zone is ready to
change temperature.
Press arrow UP/DOWN keys to scroll and select the desired temperature,
Press zone key again to engage /set the temperature.
Adopt the same process to select and set temperature for the other zone/
compartment.
