4
Use of these operating
instructions
This symbol indicates warnings which you must read before use:
Display and error messages
Symbol / Question /
Description of error
Explanation
Solution
The jar is not sealed correctly or the safety switch is not working.
Please check the seal again.
The kitchen machine has an error in the electrical circuit.
Please contact 1300 373 199 for
directions.
The motor is overloaded.
Please switch the kitchen machine off
and wait a few minutes until the motor
has cooled down.
The kitchen machine stops
when the whisk paddle is used.
The kitchen machine has a special control system. The speed can vary
and the rotation is interrupted in 2-second intervals. This means that the
kitchen machine starts making an unusual noise. This is normal. This
noise means that the speed of the knife is being adjusted to prevent the
motor overheating.
Remove part of the mixture or increase
the speed to a maximum of 3.
The speed is irregular or the
motor is sticking.
Increase the speed from 1 to 2 or from
2 to 3.
The knife is working very slowly
when preparing dough.
Please check whether you have exceeded the maximum of 500 g of flour.
Remove some of the mixture from the jar.
There is smoke coming from
the kitchen machine.
The motor is overheating. Check the maximum fill level.
Remove some of the mixture from the jar.
Allow the kitchen machine to cool down
for around 20 minutes.
Kitchen machine not working
with the temperature set and
speed set over 5.
The temperature can only be set for speeds 1 to 4.
Change the speed setting to 1 to 4.
Jar is difficult to fit.
Positioning the jar gets easier with use, as the silicon seal alters as a
function of the heat and humidity, while still forming a seal.
Rub a little cooking oil into the silicon seal
or moisten it.
Is the kitchen machine used?
The jar base shows marks and
residual moisture on delivery.
All kitchen machine modules are tested prior to delivery. The jar is filled
with water and brought to the boil. As with a dishwasher, residual moisture
can be left behind. These residues can result in slight but perfectly safe
marks on the base of the jar.
In order to remove the marks, please use
a conventional stainless cleaner, such as
Sidol from Henkel.
Noises when first used or
under heavy load.
When first used and under heavy load, the motor can heat up and make
strange noises. As in any electric motor, e.g. in a model railway or model
motorway, the engine uses brushes needs to be ‚run in‘ to begin with. The
noises are nothing to be concerned about.
Allow the kitchen machine to cool
down after it has been working hard,
e.g. kneading firm dough. The kitchen
machine will be fully operational again
after cooling down.
Beeping noise.
The module beeps to tell you the kitchen machine has reached the right
temperature.
The beeping also indicates that the
pre-set time has run out.
