LED indications
When the wrist receiver battery is nearly depleted, the battery LED (3) starts to blink in
yellow. The charging time is up to 8 h. The charger is equipped with a battery backup and
the charger LEDs indicate the following:
LED
Indication Status
Charging LED
Green light
The receiver battery is being charged.
Mains LED
Green light
The charger is powered by mains voltage.
Mains LED
Green blinks
The charger is powered by the battery backup.
Personalizing your receiver
Changing the signal pattern
The signal pattern can only be changed on the transmitters. See
Changing the signal
pattern
for the relevant transmitter.
Changing the radio key
If your Visit system is activated for no reason, there is probably a nearby system that
triggers yours. In order to avoid radio interference, you need to change the radio key on
all units. The radio key switches are located on the
transmitters
.
1
Open the transmitter cover and move any radio key switch to the up (on position) to
change the radio key. See
Changing the radio key
for the relevant transmitter.
2
Press and hold the function button on the Wrist receiver until the green and yellow
Visit LEDs (1) blink alternately. Release the button.
3
Press the test button/s on the transmitter within 30 seconds to send the new radio key.
4
All Visit LEDs (1) on the wrist receiver blink 5 times to show that the radio key has been
changed. It then returns to normal mode. Please note that all Visit units must be set to
the same radio key.
1
2
3
4
5
Using the bed shaker
The BE1270 Bed shaker accessory wakes
you with vibrations anything happens
while you are asleep. Connect it to the
charger port and slide it under your pillow
or mattress.
Please note that the bed shaker only works
when the wrist receiver is placed in the
charger. The receiver will not vibrate during
charging, but the Visit LEDs will act as usual.
To try the bed shaker, press the bed shaker
test button on top of the charger.
Charging the Wrist receiver
1
Angle the receiver slightly outwards so
that the two small holes on the edge of
the wrist receiver point downwards
Press the receiver and the moveable
button downwards.
2
Move the upper part of the wrist receiver
towards the back edge and release care-
fully. The green LED (X) should light up.
Removing it from the charger
3
Press the wrist receiver and the moveable
button downwards.
4
Angle the upper part of the wrist
receiver.
5
Lift the wrist receiver out of the charger.
1
2
3
4
3
4
5