TIMER INSTRUCTIONS
Page 6
TIME SETTING
To set the current time turn the minute Hand clockwise. Do not set the time by Rotating the “outer” dial.
Turn the minute hand clockwise until the time of day on the outer dial is aligned with the triangle
marker on the inner dial (two o’clock position).
Example for 24-hour program dial 11:00 AM. Turn the minute hand clockwise until 11:00 AM is aligned
with the triangle on the inner dial. The hour and the minute dial will show exactly 11:00.
The 24-Hour dial has quarter-hour divisions and AM/PM indications.
The time switch is programmed by pushing the captive trippers to the outer ring position for the entire
period that the load is to be turned “ON”, i.e., fifteen minutes for each tripper on the 24-Hour dial.
When the tripper is pushed to the inside, the switch is in the “OFF” position.
OPERATION
With the Time Clock programmed and set in Automatic Mode
The time clock will switch “ON” and “OFF” Channel 4 controlling the pump.
With the Time Clock “OFF”
Channel 4 can be switched “ON” & “OFF” from the PCT-3 Transmitter.
With the Time Clock “ON”
The PCT-3 Transmitter cannot switch “OFF” Channel 4.
NOTE: If the Channel 4 button on the PCT-3 Transmitter is pressed when the
Time Clock is “ON” channel 4 will stay “ON” after the time clock switches “OFF”
until channel 4 is turned “OFF” by the PCT-3 Transmitter.
TABS IN
TO SET “OFF”
OPERATION
TABS OUT
TO SET “ON”
OPERATION
