2014-10-08 – Page 4
Table tops will be approximately 30” above the ground.
Seats will be approximately 18” above the ground.
Dimensions shown may vary based on installation and manufacture.
www.belson.com
STEP #5:
Please Note:
this is at least a two-person
operation.
Carefully turn table right side up
and tighten all hardware in an alternating
pattern to keep the frames straight under the
tops and seats. Use a level to verify table
frame, top and seats are level and plumb.
Pick table up off ground and carry to desired
location, using caution not to drag table
across any surface.
STEP #4:
Fit the seats to the attachment brackets as shown, and secure each seat with hex bolt, two washers, nylon lock nut
and bolt guard at each connection. Hand tighten hardware at this time.
SEAT
TABLE TOP
NYLON
LOCK NUT
FLAT WASHERS HEX BOLT
BOLT GUARD
H-FRAME TO SEAT
1 - 5/16” X 1-1/2” HEX BOLT
2 - 5/16” FLAT WASHER
1 - 5/16” NYLON LOCK NUT
1 - 5/16” BOLT GUARD
60-1/4”
29-1/4”
71-1/4”
53-3/4”
95-1/4”
25-3/4”
30”
18”
25-3/4”
10-1/4”
2”
