Doc 0203120 rev O
Page 24 of 32
Not subject to issue control when printed
Replace Parts - (Milano 70 is shown)
When changing the bot HSG the ID plate must be transfered to new HSG. Please note that the ID plate is not an available spare part. Push out the
plate from inside the old HSG by using a tweezer. Place the side of the ID plate with one prong and insert it. Use a finger to press down to make sure
both sides are correct in place
ID Plate
Two
prong
One
prong
Push
out
Replacing the toggle:
Press down until toggle clicks off. Place index finger and thumb on the sides of toggle and lift off. Ensure that the silicone cap
is correct in place. Mount the new toggle (or VC cover) in correct position with the small arrow pointing towards PB. Press down the toggle until it
clicks in place
Gap
