24
25
Using the Mode button
The Mode button (see page 9) is utilized to view current mode,
switch between different input modes and check the battery sta-
tus of the myPAL Pro.
Current mode:
To view the current mode of operation, press the Mode but-
ton once. The corresponding mode LED on the backside of the
myPAL Pro will light up for 3 seconds.
Changing mode:
To change the mode of operation, do the following:
1. Press the Mode button once. The Mode LED corresponding
to the current mode will be lit.
2. Within 3 seconds, press the Mode button again to change
mode.
3. Repeat step 2 until the desired mode is obtained.
Checking the battery status
To view the current battery status press and hold the Mode but-
ton for at least 3 seconds until one or more of the Mode LEDs
starts to blink.
- 75 – 100 % remaining battery capacity: All Mode LEDs blink
- 50 – 75 % remaining battery capacity: Three Mode LEDs
blink (FM + Line-in + TC)
- 25 – 50 % remaining battery capacity: Two Mode LEDs blink
(FM + Line-in)
- <25 % remaining battery capacity: One Mode LED blinks
(FM)
i
Note: When less than 30 minutes of operating time is left
(low battery condition) the status LED will start blinking orange
(see Light Indicator chapter).
Summary of Contents for myPAL Pro
Page 1: ...Beltone myPAL Pro Instructions for use...
Page 26: ...50 51...
