26
27
CLEANING THE STRAINER
THIS PRODUCT WILL NOT OPERATE
PROPERLY IF THE STRAINER IS
CLOGGED. PLEASE CLEAN THE
STRAINER REGULARLY.
•
Close the water shut off valve.
•
Flush the toilet to empty the
water reservoir.
•
Unscrew the water hose nut.
•
Clean the strainer with a small
brush or water.
•
Re-screw the water hose nut.
•
Open the water shut off valve.
PROBLEM POSSIBLE CAUSE
POSSIBLE SOLUTION
The washing
water does
not spray
•
The water tank
is not filled.
•
The shutoff
valve is closed.
•
Freezing inside the
main unit or the
water supply pipe.
•
Wait about one minute.
Press the desired washing
button once again.
•
Turn the shutoff
valve to open.
•
Heat the room (for about
two hours). Operating the
unit while parts are frozen
will cause a malfunction.
The unit
is not
operating.
•
Disconnect the
power cord.
•
The seat is not
occupied
•
Connect the power cord.
If problem persists, check
the power cord supply
system in your house
•
Occupy the seat
(The unit has an
occupied seat sensor).
Water is
leaking.
•
Check the water
supply system
•
If the water is leaking from
the main unit, call the
service center or the place
you purchased the unit.
The
washing
water
pressure
is weak
•
The water pressure
level is set to “LOW”
•
The strainer
is clogged.
•
Set the water pressure
to be “HIGH.”
•
Clean the strainer
The washing
water is
not warm
•
The water
temperature is
set to “LOW.”
•
Continuous
Operation has
depleted the supply
of warm water.
•
Set the water pressure to
“HIGH.”
•
Clean the strainer.
The seat
and dryer is
not warm
•
The seat & dryer
temperature is
set to “LOW.”
•
Set the seat & dryer
temperature
to “HIGH.”
TROUBLESHOOTING GUIDE
MAINTENANCE (CONT.)
Summary of Contents for bioBidet BB800
Page 1: ...OWNER S MANUAL BB800 ...
