BEMIS bioBidet BB800, Owner'S Manual

6 

7

CAUTIONS BEFORE INSTALLATION

WIRING REQUIREMENT 

This product MUST be plugged into a regular voltage Grounded GFCI outlet 
(North America 120V ac, 60Hz/ Europe 220-240V ~, 50/60Hz). The rated 
power consumption is 660W/600-700W. In locations where only a standard 
two-prong outlet is available, it is the responsibility of the user to install a 
grounded three-prong outlet. Using a higher voltage is dangerous and may 
result in a fire or other accident. This product is not responsible for damage 
resulting from the use of it on other than specified voltage, or operating it 
without proper grounding. 

WARNING

This product must be on a separate circuit. No other appliance should share 
the circuit with this product. Sharing a circuit could cause the branch circuit 
fuse to blow or the circuit breaker to trip. Continuous usage under these 
conditions could result in fire or property damage. 

GROUNDING INSTRUCTIONS

•

This product has a three-prong grounding plug, which must be plugged 
into an outlet that is properly installed and grounded. In the event of an 
electrical short circuit, grounding reduces the risk of electric shock by 
providing an escape wire for the electric current. If repair or replacement 
of the cord or plug is necessary, do not connect the grounding wire to 
either flat blade terminal. The wire with insulation having an outer surface 
that is green with or without yellow stripes is the grounding wire. Check 
with a qualified electrician or serviceman if the grounding instructions are 
not completely understood, or if in doubt as to whether the product is 
properly grounded. 

•

This product is for use on a nominal 120V circuit, and has a grounding 
plug that looks like the plug illustrated in sketch A in Figure 1. A 
temporary adapter, which looks like the adapter illustrated in sketches 
B and C, may be used to connect this plug to a 2-pole receptacle as 
shown in sketch B if a properly grounded outlet is not available. The 
temporary adapter should be used only until a properly grounded outlet 
(sketch A) can be installed by a qualified electrician. The green colored 
rigid ear, lug, or the like extending from the adapter must be connected 
to a permanent ground such as a properly grounded outlet box cover. 
Whenever the adapter is used, it must be held in place by a screw.  
 

THIS APPLIANCE HAS TO BE EARTHED.