18
19
4. If the unit does not work after replacing the batteries, unplug
and wait for 3 seconds. Plug in again.
5. Remote Control ID Setting
ID setting is required to protect the remote signal interruption if more than one
bidet seat is installed at one place (public toilets)
•
After replacing the batteries, ID of the unit will be initialized as “00”
(factory initialization) and its ID will be equalized ID of the remote control
that reaches the unit first. This ID assigning function will be needed to
prevent signal interruption of more than 2 units are used at one place. In
case of using one unit only, no setting is needed.
•
If you want to change the ID, please refer to “Remote Control ID Setting”
•
The remote should be located near by the main unit when ID is set.
•
Default ID of remote is “0”
•
In case of battery replacement, power resetting of main unit or
factory initialization, ID will be initialized, “0,” and setting process
should be done again.
1. Press Nozzle Control
“Down” for 3 seconds.
The indicator of
“Nozzle Cleaning”
blinks and the unit
is ready for ID setting.
2. Set the ID by pressing
Power Control “+” or “-”
(1~5 IDs available)
3. Press “Stop” to save
the ID. The main unit
will be synchronized
simultaneously.
REMOTE INSTALLATION (CONT.)
