WallSafe
®
Wall Bracket and Key Set
Soporte de pared y juego de llaves / Support mural et jeu de clés
Model 405 020 / Modelo 405 020 / Modèle 405 020
Model 410 020 / Modelo 410 020 / Modèle 410 020
Rev. 2.0
©2017 599 0510
HEALTH CARE™
INCLUDED IN PACKAGE
10 Bemis WallSafe Brackets
44 Plastic Wall Plugs
44 1-1/4" Pan Head 10-Gauge Screws
Mount WallSafe Bracket at a safely accessible
height approximately 50" from top edge to floor.
EN EL PAQUETE SE INCLUYEN
10 Soportes para montaje Bemis WallSafe
®
44 Taquetes de plástico para pared
44 Tornillos de cabeza troncocónica de calibre 10 de 1-1/4 pulgadas
Monte el soporte WallSafe a una altura accesible de manera segura,
aproximadamente a 50 pulgadas desde la orilla superior hasta el piso.
COMPRIS DANS L’ENSEMBLE
10 supports Bemis WallSafe
®
44 capuchons muraux en plastique
44 vis à tête cylindrique de 3,2 cm (1-1/4 po), de calibre 10
Montez le support WallSafe à une hauteur aisément accessible
de manière sécuritaire, soit à environ 127 cm (50 po) du sol au
bord supérieur du support.
MASONRY WALLS
1. Using the WallSafe Bracket as a template, locate it on the
wall in the desired position and drill locating reference points
at each screw hole.
2. Drill 1/4
"
diameter holes 1-1/4
"
deep. Blow dust out of the
holes and insert plastic wall plugs, tapping them with a
hammer if needed to bring them flush to the wall. Screw
on the WallSafe Bracket with the provided screws.
Note:
If for any reason the provided screws are not used,
only pan head or round head 10-gauge screws should be
substituted. In no case should countersunk screws be used.
HOLLOW WALLS
Metal expanding wall fasteners that require a 3/8
"
drill hole
size or plastic toggle expanding wall fasteners that require
a 5/16
"
drill hole size should be used. Fasteners requiring
smaller diameter holes have screw heads that are too small
for secure wall bracket fastening.
Typical recommended fasteners are:
Molly fastener
CD6S
Metal fastener for 3/8
"
to 5/8
"
wallboard
Rawl anchor
2112
Metal fastener for 3/8
"
to 5/8
"
wallboard
Poly-Toggle anchor
2304
Plastic toggle fastener for 1/2
"
wallboard
Poly-Toggle anchor
2305
Plastic toggle fastener for 5/8
"
wallboard
Use WallSafe Bracket Key to remove
sharps container from bracket.
Mounting Instructions
Bemis Manufacturing Co., 300 Mill Street, Sheboygan Falls, WI 53085
920-467-4621 • 800-558-7651 • Fax 800-499-8160
E-mail: HCG@BemisMfg.com • www.bemishealthcare.com
